Reeves Amplification Discussion Group Forum Index Reeves Amplification Discussion Group
Discussion board about Reeves amplifiers
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

12at7 substitution

 
Post new topic   Reply to topic    Reeves Amplification Discussion Group Forum Index -> Tubes, Speakers, and Amp Components
View previous topic :: View next topic  
Author Message
Glass Onion



Joined: 25 Jun 2008
Posts: 6
PostPosted: Wed Nov 19, 2008 11:30 am    Post subject: 12at7 substitution Reply with quote
So the question is can I put a 12at7 in the first preamp slot or the extra gain stage slot of my Custom Lead High Gain. If I do the substitution will I need to think about rebiasing. Any thoughts would be greatly appreciated.
Back to top
View user's profile Send private message
wisejr89



Joined: 12 Sep 2009
Posts: 1
PostPosted: Sat Sep 12, 2009 6:02 am    Post subject: at7 setup Reply with quote
hey onion

you dont need to rebias any sort of preamp, its the output stage and not the distribution stage.

the at7 is a really clean, low gain tube and it would probably clean the tone up a lot. and since it is low gain, it wont break up and will last longer.

hope i was able to help.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Reeves Amplification Discussion Group Forum Index -> Tubes, Speakers, and Amp Components All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group
Protected by Anti-Spam ACP